Honeywell Trane TCONT802AS32DA Instruction Manual

Honeywell Trane TCONT802AS32DA Istallation Instructions

The TCONT802AS32DA and TCONT803AS32DA Touch Screen Comfort Controls provide electronic control of 24 Vac heating and cooling systems. See Table 1 for a general description

Honeywell Trane TCONT802AS32DA INSTALLATION

When Installing this Product...

  1. Read these instructions carefully. Failure to follow the instructions can damage the product or cause a hazardous condition.
  2. Installer must be a trained, experienced service technician.
  3. After completing installation, use these instructions to check out the product operation.

Do not install the comfort control where it can be affected by:

  • — Drafts or dead spots behind doors and in corners.
  • Hot or cold air from ducts.
  • Radiant heat from sun or appliances.
  • Concealed pipes and chimneys.
  • Unheated (uncooled) areas such as an outside wall behind the comfort control

Honeywell Trane TCONT802AS32DA Wallplate Installation

The comfort control can be mounted horizontally on the wall or on a 4 in. x 2 in. (101.6 mm x 50.8 mm) wiring box.

  1. Position and level the wallplate (for appearance only).
  2. Use a pencil to mark the mounting holes.   
  3. Remove the wallplate from the wall and, if drywall, drill two 3/16-in. holes in the wall, as marked. For firmer material such as plaster, drill two 7/32-in. holes. Gently tap anchors (provided) into the drilled holes until flush with the wall.
  4. Position the wallplate over the holes, pulling wires through the wiring opening. See Fig. 2.
  5. Insert mounting screws into the holes and tighten.

Honeywell Trane TCONT802AS32DA WIRING

All wiring must comply with local electrical codes and ordinances.

  1. Select set of terminal identifications (Table 2) that corresponds with system type (heat/cool or heat pump in Fig. 3).
  2. Loosen the screws for the appropriate system type selected; see Table 2. Insert wires in the terminal block under the loosened screw. See Fig. 4.
  3. Securely tighten each screw.
  4. Push excess wire back into the hole.
  5. Plug the hole with nonflammable insulation to prevent drafts from affecting the comfort control.

Read More Honeywell Trane TCONT802AS32DA Instruction Manual pdf Below

Honeywell Trane TCONT802AS32DA Instruction Manual