Duromax XP4850EH Manual
DuroMax has cemented its reputation as one of the markets leading power equipment companies who are headquartered in the US. All of our products are manufactured to the strictest guidelines and go through countless testing in all phases of production.
Evolving our strong engine line, DuroMax has complemented its offerings to include Pressure Washers, Water Pumps, Engines and now offering V-Twin engines. Reliability is the highest standard we hold ourselves to, whether its powering a heater during a winter storm that knocks out power, dewatering a flooded property, or washing away a deck for the summer season
Duromax XP4850EH QUICK START GUIDE (GASOLINE)
-
Remove shipping braces. The shipping braces prevent engine movement during shipment. Flip the generator over and remove the brightly colored brace between the motor and the frame, and the wood brace under the generator.
-
Add oil. The oil fill cap is located on the lower engine block to the right of the recoil start housing. Remove the oil fill cap and fill with 10w30 oil.
-
Add gasoline The fuel cap is located on top of the fuel tank. Fill the tank with fresh unleaded gasoline 87 octane or higher. The tank is full when you see fuel in the bottom of the fuel filter cup. DO NOT overfill the tank.
-
Turn breaker o The breaker is located on the right side of the front power panel. Flip the breaker down to prevent accidental load when starting the generator.
-
Turn gas valve on. The gas valve is located above the recoil start on the bottom of the fuel tank. Rotate the valve clockwise to the vertical position to turn on the gas supply.
-
Close choke. The choke lever is located above the air filter to the right of the recoil start. Slide the lever to the left to cut the air supply and allow more gas into the engine to start.
-
Start generator. The key switch is located on the left side of the front power panel. Insert the key and turn to the start position to start the generator. Allow the key to return to the run position once started.
-
Open choke, The choke lever is located above the air filter to the right of the recoil start. Slide the lever to the right to open the choke and increase air into the carburetor for normal running.
-
Turn breaker on. The breaker is located on the right side of the front power panel. Flip the breaker up to allow power to flow to the receptacles.
-
Connect devices. Connect your devices to the receptacles on the front panel. Start with the largest loads first.
Duromax XP4850EH QUICK START GUIDE (PROPANE)
-
Remove shipping braces. The shipping braces prevent engine movement during shipment. Flip the generator over and remove the brightly colored brace between the motor and the frame, and the wood brace under the generator.
-
Add oil. The oil fill cap is located on the lower engine block to the right of the recoil start housing. Remove the oil fill cap and fill with 10w30 oil.
-
Turn breaker o. The breaker is located on the right side of the front power panel. Flip the breaker down to prevent accidental load when starting the generator.
-
Turn gas valve o. The gas valve is located above the recoil start on the bottom of the fuel tank. Rotate the valve counter clockwise to the horizontal position to stop the flow of gasoline to the carburetor.
-
Connect propane hose. The propane regulator / decompression valve is located on the frame of the generator below the OHV valve cover. Ensure the propane hose is securely connected to the regulator/compression valve.
-
Connect propane tank. The propane hose is located on the left side ofthe regulator, below the OHV valve cover. Screw the open ACME nut connection to your propane tank and turn the tank on.
-
Release propane pressure. The propane regulator / decompression valve is located on the frame of the generator below the OHV valve cover. Press the button in the center down 3-5 times for one second to clear the air from the lines and fill the ca rburetor.
-
Adjust choke. The choke lever is located above the air filter to the right of the recoil start. Slide the lever to the right to open the choke and increase air into the carburetor for normal running.
-
Start. The key switch is located on the left side of the front power panel. Insert the key and turn to the start position to start the generator. Allow the key to return to the run position once started.
-
Turn breaker on / connect. The breaker is located on the right side of the front power panel. Flip the breaker up to allow power to flow to the receptacles. Connect your devices to the receptacles on the front panel. Start with the largest loads first.
Duromax XP4850EH Generator Components
- Air Cleaner - a removable, cleanable, oiled, sponge-like element that cleans the air going into the engine.
- Choke Lever - Allows the airflow into the carburetor to be restricted to assist in starting the engine.
- Fuel Gauge - Indicates the amount of fuel in the gasoline tank.
- Fuel Cap - Allows access to fill the gasoline tank.
- Circuit Breaker - Resettable switch that protects the generator from electrical overload.
- 120/240v 4-Prong Receptacle - Use to connect electrical devices that run 120 or 240 Volt, 60Hz, single phase, AC current (NEMA L 14-30).
- Ground Terminal - Connect a ground wire here to properly ground the generator.
- 120v 3-Prong Receptacle - Use to connect electrical devices that run 120 Volt, 60 Hz, single phase, AC current (NEMA 5-20).
- Battery - 12V DC 7ah Battery that powers the Electric Start System.
- Volt Meter - Provides reading of voltage output
- 12v DC Charging Posts - DC Output for charging batteries or running small DC powered items.
- Oil Fill and Dipstick - Use to add or check the oil.
- Engine Switch - 3 Position Switch to "Start", "Run", or turn "Off' the generator.
- Recoil Start - Easy Pull Recoil Start to start the engine without the electric start.
- Fuel Filter Cup - Traps dirt and debris in gasoline before it enters the engine.
- Fuel Valve - On/OffValve that allows fuel into the engine.
- Spark plug - Provides ignition to the engine.
- Mug er - Reduces engine emissions and reduces noise.
- Propane Tank Connector and Hose - Connects the LPG tank to the LPG Regulator.
- Propane Regulator and Pressure Release Valve - Provides a regulated LPG Fuel supply to the engine. (Intended for use with a LPG Source of 3 PSI or more.)
Duromax XP4850EH Features
Plenty of Power – With 4,850 starting watts and 3,850 running watts, this unit can handle heavy loads, from lights and a refrigerator to a home air conditioner and high amperage power tools.
Dual Fuel Technology – This generator runs on gasoline or propane, giving you the freedom and flexibility of fuel choice. Why Dual Fuel? Learn more about Dual Fuel technology CLICK HERE
Powerful Engine – The DuroMax 212cc OHV engine is a workhorse that provides plenty of power to handle multiple jobs, from powering high voltage appliances to heavy duty power tools.
MX2 Technology - Get the maximum power from each of the 120-Volt receptacles. Choose between operating the generator at both 120V and 240V simultaneously, or at 120V only with full power. Ideal for usage with RVs.
Low Oil Shutoff – Protects your investment by automatically shutting the generator off when it senses that the oil is low.
Fully Featured Power Panel – The power panel includes a wide selection of outlets for maximum compatibility in your applications including: 2 120V household GFCI outlets and 1 120/240V 30A twist lock outlet. The panel also includes a voltmeter and 12V DC charging posts for charging external batteries.
Complies with Emissions Standards – All DuroMax generators are both approved by the EPA (Environmental Protection Agency) and CARB (California Air Resources Board) and follow strict guidelines to ensure our generators are as environmentally friendly as possible.
Duromax XP4850EH Spesifications Review
Duromax XP4850EH Power Spesification
GASOLINE | |
---|---|
Peak Watts | 4,850 |
Running Watts | 3,850 |
Peak Amps @ 120V | 40.42 |
Running Amps @ 120V | 32.08 |
Peak Amps @ 240V | 20.21 |
Running Amps @ 240V | 16.04 |
PROPANE | |
---|---|
Peak Watts | 4,608 |
Running Watts | 3,658 |
Peak Amps @ 120V | 38.40 |
Running Amps @ 120V | 30.48 |
Peak Amps @ 240V | 19.20 |
Running Amps @ 240V | 15.24 |
Duromax XP4850EH Product Spesifications
Amperage | 32.08A / 16.04A |
Voltage | 120V / 240VAC & 12VDC |
Frequency | 60 Hz |
Engine Size | 212 cc |
Engine Type | 4-Cycle Air-Cooled Spark-Ignition |
Engine Speed | 3600 rpm |
Fuel Type | Gasoline / Propane |
Fuel Tank Capacity (Gasoline) | 3.96 gal |
Suggested Tank Size (Propane) | 20 lbs |
Runtime (Gasoline) at 50% Load | 10.42 hrs |
Runtime (Propane) at 50% Load | 8.92 hrs |
Start Type | Electric / Recoil |
Volume Level | 69 dB |
EPA Certified | Yes |
CARB Certified | Yes |
Product Dimensions | 25" L x 24" W x 21" H |
Product Weight | 122 lbs |
UPC | 811640013783 |
Readmore and Download Duromax XP4850EH Manual
Title | : Duromax XP4850EH Manual |
Format | |
Pages | : 68 Pages |
Language | : English |
Model | : XP4850EH |
Category | : Power Generator |
Size | : 96 MB |