Relion ULTRASONIC HUMIDIFIER Model H-0565-0 Series Manual
RELI-ON ULTRASONIC HUMIDIFIER
Relion ULTRASONIC HUMIDIFIER Model H-0565-0 Operation Instructions
- Make sure there is water in the water tank.
- Water level must be adequate in the base in order for the unit to produce mist. This unit does not have an automatic shut off.
- Switch is in the “OFF” position, plug cord into a 120 volt AC wall outlet.
- Slide to “ON” position. Indicator will illuminate when power is on.
- Set mist intensity control. Slide control to the right to increase mist output, slide to the left to decrease mist output.
- Allow a few minutes for water to fill the reservoir to produce mist. It may take up to thirty minutes to saturate if you are using a new demineralization cartridge for mist to appear.
- Turn off, reduce mist intensity, or open door to room if indoor relative humidity is above 50% or condensation forms on the wall or windows.
- Make sure the power is off when moving the unit or refilling the water tank. The fan will continue to operate even if the water tank is empty.
- In case of high temperature or filtration malfunction, this product may produce a sour or amino acid smell. If this occurs please rinse the filter with distilled water or replace the filter.
- If you have any questions or comments, call toll-free 1-866-872-7442.
Filling the Water Tank
- Remove mist nozzle from the water tank. Turn tank upside down after removing it from the base. Open tank by turning cap counterclockwise. Rinse and wipe clean.
- Fill the water tank with cool tap water and replace the cap. Turn upside down to check for leaks. If leaks appear, remove cap and re-tighten. Be sure the rubber tank ring is properly placed to minimize leaks. Use of very cold water may temporarily hinder mist output. Filling humidifier with hot or warm water could cause damage to the unit. To reduce lime or calcium deposit in your unit, it is recommended to use the Kaz Demineralization Cartridge (Model DC-51). Distilled water may be used to reduce mineral deposits. Keep base and nebulizer clean for more effective mist output.
- Replace water tank on the base and reposition the mist nozzle on the tank.
- If white dust occurs due to hard/soft water, please change to distilled water.
Cleaning Instructions
For best results, clean your humidifier at least once a week.
To begin:
- Turn off and unplug humidifier
- Empty water in tank and base of humidifier
- Remove filter cartridge
To clean base:
- Mix two tablespoons white vinegar to two cups of water.
- With a soft cloth and/or a cotton ball, dip into the solution, wiping the entire base area, being very careful not to damage any components. Be sure to clean the transducer- located at the bottom of the base; it is a little round silver disk. Be very careful not to damage transducer.
- Next with a soft cloth or a cotton ball dip into plain water (you are basically rinsing) wiping base and transducer being very carefully not to damage any components
- Set aside to dry
To clean tank:
- Mix two tablespoons of bleach to 1 gallon of water. (The tank is a two gallon tank so fill the tank half way then add the bleach).
- Put approximately 2 cups of the solution in the tank.
- Shake the tank. Dump out solution.
- Put approximately 2 cups of plain water in tank.
- Shake the tank. Dump out water.
- Take soft dry cloth (you can actually reach up into tank) and dry entire tank.
- Do this once a week.
- For best results, replace the filter every 45 uses or 240 hours. The Kaz Demineralization Cartridge (Model DC-51) can be purchased at Wal- Mart. If you have trouble removing the tank cap, try adding liquid soap around the cap in order to loosen it.
If you have trouble removing the tank cap, try adding liquid soap around the cap in order to loosen it.
Relion ULTRASONIC HUMIDIFIER Model H-0565-0 Series Manual
Title | : Relion ULTRASONIC HUMIDIFIER Model H-0565-0 Series Manual |
Format | |
Pages | : 4 Pages |
Language | : English |
File Size | : 2 MB |