MXMA 4800 Cone Valve Service Workshop Manual

About MXMA 4800 Cone Valve Service Workshop Manual

Read this MXMA 4800 Cone Valve Service Workshop Repair Manual carefully and thoroughly before beginning work. It contains useful information and tips that will help you repair and maintain your suspension. This MXMA 4800 Cone Valve Service Workshop Manual assumes that the necessary special WP tools and WP workplace and workshop equipment are available.

We shall not provide a description of general workshop methods. Likewise, safety rules that apply in a workshop are not specified here. It is assumed that repair work will be performed by a fully trained mechanic.

Special tools are necessary for certain tasks. The tools are not contained in the delivery contents but can be ordered under the number in parentheses. E.g.: (T1290 INNER T. DISASSEMBLY TOOL D35/D40 ) During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, O-rings, pins, lock washers) must be replaced by new parts.

In some instances, a thread locker (e.g. Loctite®) is required. The manufacturer instructions for use must be followed. After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged or worn parts.

After you complete the repair or service work, check the operating safety of the vehicle. The work prescribed in the service schedule must be carried out by an authorized WP workshop only otherwise, all warranty claims will be void. No warranty claims can be considered for damage resulting from manipulations and/or alterations to the vehicle.

MXMA 4800 Cone Valve DISASSEMBLING THE FORK LEGS

The fork legs are disassembled.

  • Remove protective cover on the bottom of the fork legs
  • Note down the present state of rebound and compression damping
  • Completely open the adjuster of the rebound damping and compression damping.

Readmore and Download MXMA 4800 Cone Valve Service Workshop Manual PDF Below

MXMA 4800 Cone Valve Service Workshop Manual